Gluing up some blanks for the new year!


Olo of the Sun 19 foot surfboard: rail shaping.

The bottom of the olo has been faired, it has a concave through the nose and mid section which diminishes and runs into a flat area four feet from the tail. Hand sanding the bottom has taken approximately 14 hours.



Now the rail faceting continues: a continuous 50/50 slightly elliptical section.



Minty Fresh

Last week I glassed my girlfriend Hannah's new Canvas Purcha$e. It was the first longboard I've ever lammed but I wanted it to be unique and special for her, and made with love, so I just went ahead and charged it while the laminator wasn't there. I went into it thinking it'd be easy after all the boards I've seen laminated lately but dang, it's a lot harder to do than I thought. I started on the bottom with four different colors and that was hardest part. My first color started going off before I got to the last color which made it a bit tricky. All in all, it came out pretty rad and we're stoked on it. I can't wait for her to ride it !! You can't miss Kameron Brown's board to the left too! That thing's sick! He shaped and lammed it himself.

Canvas Blog Here

Surfboard fin guide part 3: The dreaded flat spot, fin flex.

This example of the typical flat spot showed up today on magicseaweed.. . a great example of how not to foil a fin:





The flat spot shown above extends over three quarters of the fin base and half the height of the fin, it will cause flow separation, a decreased ability to handle high angles of attack, stalling,  and unnecessary drag.



With care and a sanding block the fin could be fixed in an hour or two. .  something most people, even the supposedly 'best' fin makers usually can't be bothered to do. 



http://olosurfer-woodensurfboardsatpipeline.blogspot.com/2009/01/surfboard-fin-guide-part-one-flat-spot.html



http://olosurfer-woodensurfboardsatpipeline.blogspot.com/2009/01/surfboard-fin-guide-part-two-flat-spot.html



Flexy or stiff ?



The main factor which will increase stiffness is the thickness to height ratio of the fin ( regardless of the type of glass orcore used). If one prefers the fin to be stiffer just make it thicker, and keep greater thickness into the tip, tapering it less.  Extending the fore and aft length of the fin will prevent the chord ratio from becoming too low. Bringing the position of maximum chord thickness back to about 40 to 45% aft will help lower drag on a thicker fin also.



Fin flex on an upright pivot fin as shown below is not beneficial, it only works to advantage on a low, highly raked fin where the flex gives a motion like a fish tail.  Even the standard Greenough/Liddle dolphin fin shape is insufficiently raked for beneficial flex. We prefer to use a fore and aft rake to height ratio of less than 1:1, the pivot  fin is closer to 1:3.



Pick Up Sticks

9'8" Purcha$e With a Wild Tear Drop Concave

5'4" Butterzone Getting Shacked