Here the mid section of the panel which was glued yesterday is ready for the nose components and most of the tail. The tail will be done in two sessions to avoid creep.
Mixing 100mls of resin at a time, about 700 to 800mls are required for the entire panel
Resin is spread on to both sides of each block, rather than on to the frames. No marking is needed this way. If glue is applied to the frames they need to be marked to show where it should be applied, which is tedious.
Glue is squeezed out gently, with a see saw motion.
The Baron 12 foot power surfboard may well be described as the Rolls Royce of luxury expensive wave riding craft !To be continued . . .. . .
Mixing 100mls of resin at a time, about 700 to 800mls are required for the entire panel
Resin is spread on to both sides of each block, rather than on to the frames. No marking is needed this way. If glue is applied to the frames they need to be marked to show where it should be applied, which is tedious.
Glue is squeezed out gently, with a see saw motion.
The Baron 12 foot power surfboard may well be described as the Rolls Royce of luxury expensive wave riding craft !To be continued . . .. . .
